here to Contact us about this item
72" x 0.065" Voss / Ungerer Precision Leveller
-17 WORK ROLLS
9 OVER 10
-84" ROLL FACE
-1.846" DIAMETER ROLLS
-7 FLIGHTS OF BACK UPS
6 FLIGHTS ADJUSTABLE
MANUAL ADJUSTMENT LEVERS
(CENTER FLIGHT FIXED)
-40 HP AC MAIN DRIVE MOTOR
880 RPM, 220/440 V
BALDOR VARIABLE FREQUENCY DRIVE (RATED AT 50 HP)
The leveller capacity is actually greater than what the I.D. tag indicates. It could be up to 0.125" or greater
depending on the material.
the work rolls are bigger than would be expected if it were only 0.065"
A number of spare parts are included with the leveller.
A set of work rolls is included which would have to be reworked.
The backup bearings should probably be replaced or reground.
Equipped with a small forced lube system for the gearbox and drive shafts.
This has minimized the wear on these components.
Everything was working fine when the unit was shut down.
The lube system was put on in 2000 after all the work rolls and drive shafts were replaced of which there are spares.
The leveller is 56" wide by 248" long and 102" high.
Weight is approximately 20,000 lbs.
There are controls for opening and closing the leveller,
the exit and entry tilt are done mechanically using a lever
The height of the leveller can be read from the large dial mounted on the front of the leveller frame.
The backup rolls are controlled mechanically using levelers.
The main motor is AC (40HP 825RPM) and is controlled by a Baldor vector drive.
About StrongMach | Features
| Catalog | Contact
Copyright © 1998 StrongMach, Inc.